Search results for "Asphalt rubber"
showing 9 items of 9 documents
THE RESISTANCE TO FATIGUE OF DRY ASPHALT RUBBER CONCRETE FOR SUB-BALLAST LAYER
2015
The more and more frequent use of recycled materials within the road and railway infrastructures is now an irreversible trend. In this area the use of Dry Asphalt Rubber Concrete (DARC) in sub-ballast layer seems to be a suitable technique to reach high mechanical and environmental performance even if such material should be analyzed over a long time horizon. This paper presents the results of experimental research focused on the resistance to fatigue of Dry Asphalt Rubber Concrete in sub-ballast layers; the survey has been carried out using four-point bending test (4pbt) on mixture samples with different rubber contents. The results of fatigue in DARC have been compared with the performanc…
DAMPING AND MECHANICAL PROPERTIES OF DRY ASPHALT RUBBER FOR SUB-BALLAST LAYERS
2011
The passage of railway lines through a town or near built-up areas poses serious environmental problems such as noise and vibration. Consequently railway companies have shown an increasing interest in developing new materials with high mechanical and environmental performance. This paper presents the results of an experimental research on the potential application of Dry Asphalt Rubber (DAR) in sub-ballast layers by measuring its damping and mechanical properties. An experimental survey based on four point bending and Marshall tests was carried to measure the stiffness modulus and damping ratio both of a standard bituminous mixture and of dry asphalt rubber mixture with a rubber content equ…
Recycled Tyre Rubber Modified Bitumens for road asphalt mixtures: A literature review
2013
AbstractNowadays, only a small percentage of waste tyres are being land-filled. The Recycled Tyre Rubber is being used in new tyres, in tyre-derived fuel, in civil engineering applications and products, in moulded rubber products, in agricultural uses, recreational and sports applications and in rubber modified asphalt applications. The benefits of using rubber modified asphalts are being more widely experienced and recognized, and the incorporation of tyres into asphalt is likely to increase. The technology with much different evidence of success demonstrated by roads built in the last 40years is the rubberised asphalt mixture obtained through the so-called “wet process” which involves the…
Improving the rheometry of rubberized bitumen: experimental and computation fluid dynamics studies
2017
Abstract Multi-phase materials are common in several fields of engineering and rheological measurements are intensively adopted for their development and quality control. Unfortunately, due to the complexity of these materials, accurate measurements can be challenging. This is the case of bitumen-rubber blends used in civil engineering as binders for several applications such as asphalt concrete for road pavements but recently also for roofing membranes. These materials can be considered as heterogeneous blends of fluid and particles with different densities. Due to this nature the two components tends to separate and this phenomenon can be enhanced with inappropriate design and mixing. Thi…
The effect of prolonged storage time on asphalt rubber binder properties
2019
Abstract This study wants to provide fundamental understanding of prolonged storage time on asphalt rubber binder properties by performing an investigation on the variation of conventional properties, rheology and morphology of four asphalt rubbers maintained at 180 °C in low shear for different digestion/storage times up to 48 h. The analysed asphalt rubbers were manufactured by combining two different asphalt binder grades, pen 35/50 and pen 50/70, with both cryogenic and ambient crumb rubber. Results have shown that keeping asphalt rubber agitated at the above mentioned processing conditions, up to 48 h, is significantly detrimental when an ambient crumb rubber is used, while it seems no…
Mechanical characterization of dry asphalt rubber concrete for base layers by means of the four bending points tests
2012
The mechanical characterisation of the asphalt concrete in terms of both the fatigue resistance and the stiffness modulus is necessary to use any design method of the flexible road pavements. Even more the determination of these mechanical properties is necessary if the asphalt concrete investigated is an innovative material as a dry asphalt rubber concrete DARC (i.e. a bituminous mixture with rubber via dry process). Such material is less known and investigated than the asphalt rubber concrete via wet process, even if its application implies peculiar economical and environmental advantages such as no specialized equipment or significant plant modifications and large quantity of recycled wa…
EXPERIMENTAL INVESTIGATION ON DRY ASPHALT RUBBER FOR SUBBALLAST
2011
The asphalt rubber mixes have a wide application field in the railroad and road superstructures because of their technical and environmental properties. While in many countries the wet process is often used to make bituminous mixtures, the dry process doesn’t have the same degree of application even though a larger recycling of waste tires rubber is allowed than the dry process. This paper focuses on the mix-design of the Dry Asphalt Rubber (DAR) for subballast of the railroad superstructure in order to define a sound laboratory procedure of mix-design with reference to Marshall test and Superpave Gyratory Compactor (SGC) test. The comparison between Marshall test and SGC test highlights th…
Experimental Survey on Dry Asphalt Rubber Concrete for Sub-ballast Layers
2012
The railway traffic through a town or near built-up areas causes heavy effects such as noise and vibration on surroundings. In order to minimize the level of these impacts the railway companies with researchers and practitioners seek suitable solutions especially in the field of the rail-track because the main source of the ground borne vibrations and noise is the bad wheel-track contact. In particular, a big effort is addressed to new materials with high mechanical and environmental performance that can be utilized within the sub-ballast layer. This paper presents the results of an experimental survey on the potential application of Dry Asphalt Rubber Concrete (DARC) in sub-ballast layers …
Towards storage-stable high-content recycled tyre rubber modified bitumen
2018
The addition of crumb rubber particles as bitumen modifier can be currently considered as a well-established alternative to conventional polymers for bitumen modification. However, Recycle Tyre Rubber (RTR) modified binders still present drawbacks such as poor mix workability and hot storage stability. Within this study the authors try unlocking the full potential of devulcanised tyre rubber-heavy oils blend, named Liquid Rubber (LR), by exploring the possibility of tailoring recycled polymer modified bitumen with unconventional high-content of RTR and designed to overcome the above mentioned technological problems of RTR modified bitumen while keeping its advantages. Results show that LR-b…